|
|
|
FRANKS SERVICE RIG National Model T-20
drawworks, S.N. A1912, with rotary clutch Model CXB5-0, rated at 220000# with 8
lines. Brewster Model N-2
Drawworks, powered by Detroit model 6-71 diesel engine, unit set up to be used
as a swab rig. HOISTING SYSTEM:
DRAWWORKS: FRANKS Model 300 Well Servicing Unit, Double Drum; Main drum
FRANKS Model 1058 38" drum with 10" Brakes;
Sand Line Drum, Model 120, 38" drum with 8" brakes; Brakes are
splash cooled; Operators control panel; Spooling capacity of main drum
is 10,950' of 9/16" line; 8,750' of 5/8" line; 6,100' of ¾"
Line; Sand Drum Line Capacity: 12,800' of 9/16" Line; 10,300' of 5/8"
Line; and 7,000' of ¾" Line; Catheads. POWER:
DETROIT, Model 6-71N diesel engine,
238 HP; complete with electric start, radiator and controls, gauges and switches
to make complete. With ALLISON Model HT750 DR Five speed automatic transmission. MAST:
PEMCO 59' H single section mast, angle iron construction with lattice framing; 4
sheave crown block, standpipe, tubing racking board, rod basket, ladder,
lighting. (Rails in mast to accommodate power swivel, travel.) (Not
sure if mast is Pemco, Might be Skytop) Hydraulic drive
assembly with hoses and controls. ALL above mounted on
WESTERN TRUCK Body, 4 axle carrier, S.N. 1283; complete with folding walkways,
stairs, and safety railings; Front and Rear Hydraulic Outriggers; PULLMASTER
hydraulic winch: front axle capacity 44,000# with 10:00 X 20 tires; Rear Axle
Capacity, 48,000 # with 10:00 X 20 tires. McKISSICK Figure 72-2
sheave 60 ton blocks, grooved for 7/8" Line, with BJ 1 ½" X 36"
Bales (Blocks rebuilt) 9,000' +/-
sand line, (Unused since installed) Atlas Clipper weight
indicator, 180,000#, with tong torque indicator. Guiberson Hydraulic Oil Saver, with 4” riser, and sinker bars, hand pump. CLICK ON PICTURE FOR LARGER VIEW.
|
